how to connect my amp to my subs!

andrewn721 · Post by **andrewn721** » Sun Oct 15, 2006 9:25 pm

http://myspace-568.vo.llnwd.net/01295/8 ... 7568_l.jpg

I have a JBL 1200.1@4ohm amp and i plan on using it to power my JL W3's d4. my subs are circuited as a parallel and has 4 plugs on the back. ([+-] [+-])/ my amp has 4 terminals (+-+-). i was wondering if i wanted to transmit 300 rms to each sub, how would i wire the amp to the sub. the image is how i think it is but im not sure. or maybe i am suppose to only use 2 terminals and have 2 wires in 1 pos terminal and 2 wires in 1 neg terminal. im not sure. how do i get 300 rms to each and what ohms should it be at?
thanks

brent · Post by **brent** » Mon Oct 16, 2006 6:46 am

You should wire your subs as shown below, and then just follow polarities into the amp. (pos to pos and neg to neg)

andrewn721 · Post by **andrewn721** » Mon Oct 16, 2006 9:59 am

posting replys to make 10 min

andrewn721 · Post by **andrewn721** » Mon Oct 16, 2006 10:00 am

heres a notehr message fsdkfhd

andrewn721 · Post by **andrewn721** » Mon Oct 16, 2006 10:00 am

xfngrthjsrthrhffdfdfdfdfdfdfxc

andrewn721 · Post by **andrewn721** » Mon Oct 16, 2006 10:00 am

one sec 2 sec 3 sec 4 how many toodles does itmake to make a noodle

andrewn721 · Post by **andrewn721** » Mon Oct 16, 2006 10:01 am

shoodle boobdle bam noozle ice breakers SDSU

andrewn721 · Post by **andrewn721** » Mon Oct 16, 2006 10:01 am

shibity shibity soooooooby nooooobi! 15 seconds

andrewn721 · Post by **andrewn721** » Mon Oct 16, 2006 10:01 am

3 more to go then i can view ur atachment!

andrewn721 · Post by **andrewn721** » Mon Oct 16, 2006 10:02 am

2 more to go then i can view ur atachment!!!!! i have to wait 15 seconds!