Sony Xpod 480 Watt Amp

Darolla · Post by **Darolla** » Thu Sep 21, 2006 7:19 pm

JeremyC wrote:Hmmm. kinda sounds like he is trying to run it at 2 ohms bridged,
.

How do I change it to a safer mode?

JeremyC · Post by **JeremyC** » Thu Sep 21, 2006 7:21 pm

Depends on the voice coil config of your subs. Let us know some more about your subs, and we can tell you how to wire it.

Darolla · Post by **Darolla** » Thu Sep 21, 2006 7:25 pm

Heres the link to ebay its the same speaker I have.

http://cm.ebay.com/cm/ck/1065-29392-2357-0?uid=297239693&site=0&ver=EOIBSA080805&lk=URL&Item=160026235461

JeremyC · Post by **JeremyC** » Thu Sep 21, 2006 7:40 pm

Yeah that link didn't help.

Find your sub on the mtx site, or woofersetc.com. and we can go from there.

JeremyC · Post by **JeremyC** » Thu Sep 21, 2006 7:45 pm

Never mind

http://www.mtx.com/caraudio/products/enclosures/TCE.cfm

If its the box with 2 12s, then its 2 ohm. You will have to pull the subs out, and wire one to each chanel of your amp, OR

Get a mono amp that can run 2 ohms.

two4fifteen · Post by **two4fifteen** » Thu Sep 21, 2006 7:52 pm

i found it on mtx's website, and if it is the 4500 like the one he linked to, it's 4 ohm. but if its the 5500, it's 2 ohm. i'm guessing the amp is just f'd. you can't expect much from a pawn shop.
http://www.mtx.com/caraudio/products/enclosures/TCE.cfm

two4fifteen · Post by **two4fifteen** » Thu Sep 21, 2006 7:54 pm

lol i was beat to the punch

Darolla · Post by **Darolla** » Thu Sep 21, 2006 7:54 pm

Here you go

http://www.woofersetc.com/index.cfm?fuseaction=product.display&Product_ID=2166

Darolla · Post by **Darolla** » Thu Sep 21, 2006 7:58 pm

I just have one twelve

two4fifteen · Post by **two4fifteen** » Thu Sep 21, 2006 8:02 pm

there's your problem. you said you were bridging your amp, and that sub is dual 4 ohm, so i'm guessing you have it wired in parallel for a 2 ohm load. a 2 ohm load won't work with most, especially sony, 2 channel amps when their bridged. that's why its going into protection, too low of an impedence. stop wasting your money on fuses, and either buy a new sub that can go with that amp (single 4 ohm or dual 2 ohm). or you can buy a new amp for that sub, like a mono 2 ohm stable.

EDIT: for now, you can try wiring each coil to each channel. that will present a 4 ohm load to each channel (that sony will thank you for it), and you might be underpowering it, but that sub doesnt need much anyway