Car Audio Central - Ultimate Car Audio Forum and Community

oh sorry. it is a 2/1 channel amp. but the subs are still being wired together so all of the amps are going to both of the subs.

2-channel car amplifier
200 watts RMS x 2 at 4 ohms (250 watts RMS x 2 at 2 ohms)
500 watts RMS x 1 at 4 ohms (4-ohm stable in bridged mode)
Low-pass crossover (50-300 Hz, 12 dB/octave)
Variable bass boost (0-10 dB at 40 Hz)
MOSFET outputs and power supply
CEA-2006 compliant
Speaker-level inputs with signal sensing for automatic turn-on
Preamp inputs and outputs
Fuse rating: 40A x 2
4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
15-7/8"W x 2-1/4"H x 10-7/8"D

Yea can still use what was suggested.

well should I go with a 4 ohm sub so that I can bridge them and still be stable with my amp?

or cant I just use one channel and run the 2ohm subs like to it like its a mono amp?

http://www.hifonicsusa.com/Hifonics_HFi_Subwoofers.html

I can get these for you $40 each + ship Full Mfg warranty.

These would fit you well!

hmm. idk they cant handle as much power as my xplods could so won't they just blow on me too? plus i was kinda looking for some pioneers or polk audio now that I really think about it. But do you honestly think that those hifonics would hit hard at all?

Do it carolina19. I just searched the hell out of the internet and chose the zeus zx12's but was keeping in mind you may want to upgrade power later on. But honestly, if you want a sub that will perform best with the box and amp you have, Ryan's choice is better. Plus, a better price.

Ryan's offer is good. I would go through him anyday and probably will.

I don't mind spending more than 40 bucks so I can get something thats not a P.O.S. I just want something that will hit hard.

As long as you have everything wired properly and your gain is set correctly, you shouldn't have a problem. I learned that the hard way.