Cant Get speaker to go

swimmerdude · Post by **swimmerdude** » Thu Jan 04, 2007 3:11 pm

Before swim practice today, i checked out all his wiring. Everything looks good, connections are all good, fuses are fine. One thing that i have never seen before was that there wasnt an actual REM wire coming out of the HU. And the amp has also been used for a while, so we need to make sure the amp even works!!

loudwagon15s · Post by **loudwagon15s** » Thu Jan 04, 2007 3:26 pm

well, the rca's are most likely okay, because i wasnt thinking and hooked up the dmm to the wrong connetions on the rca's. I think that either the remote wire isnt working, because i wasnt getting power to it with a difinitive ground, (gettin power from power connections). Or, there is a different remote wire because the only remote wire i could see was a blue one which was labeled "antenna constant". Im sure once we get power going to the remote turn on wire, the amp should fire right up

cargodz · Post by **cargodz** » Fri Jan 05, 2007 1:04 am

Put a jumper test wire on it.
just a lil piece of wire from the power to the remote and see if it turns on to make 100% that it's the remote.

lancerswimmer89 · Post by **lancerswimmer89** » Fri Jan 05, 2007 4:39 am

I'm gonna c about doing that this weekend. Cuz i would really hate to have to go out and buy another amp because the one i have took a dump.

cargodz · Post by **cargodz** » Fri Jan 05, 2007 1:14 pm

chances are... it's not the amp... hardly ever is. It's usually a wiring problem.

Car Audio Central - Ultimate Car Audio Forum and Community

Cant Get speaker to go

Wire