Bill's extended Build Update

cargodz · Post by **cargodz** » Fri Dec 01, 2006 3:08 pm

Ryan from Ohio wrote:I got the studs out of that spindle...
PITA
WIll be dropping it off tomorrow around non-early afternoon!

Awesome :happy055:
Thanks again Ryan

Ryan from Ohio · Post by **Ryan from Ohio** » Sat Dec 02, 2006 8:22 am

Looking like 2:30ish...

Watching a movie @ Franklin Park then will be out.

I pulled all 5 studs out. Just incase the other was cracked.

3 were fresh cracked, that one was broke for some time Mike. I would check them all for other possible breaks/cracks.

I got them out with a small butane soldering torch, vise and a BFH Big F'in hammer... WOuldnt fit in the press properly.

High Society · Post by **High Society** » Sat Dec 02, 2006 1:23 pm

So hows the fiesta going?

cargodz · Post by **cargodz** » Sat Dec 02, 2006 6:04 pm

We got the alt hooked up... more glass work continuing right now... and the back wheels are back on :)
The down side is that the motor doesn't want to start

I think it's a problem with the teeth on the starter or actuator in it... starts to turn over but stops.
So I got some more work ahead of me under the car now.

Hey Joe... How bout some Pizza... Bill said give him a call too.

OnYrMrk · Post by **OnYrMrk** » Sat Dec 02, 2006 10:26 pm

Pizza made it out, Jay(Pornstar) delivered it.

cargodz · Post by **cargodz** » Sun Dec 03, 2006 5:51 am

OnYrMrk wrote:Pizza made it out, Jay(Pornstar) delivered it.

Yup sure did :happy055: Thanks JOE!

Jay came back after work at around 2:30-3ish AM and he and Dusty stayed till who knows when... but they got the port walls up and the wires run to the subs and subs in... so we're ready to start testing :)

ZeroAccess · Post by **ZeroAccess** » Sun Dec 03, 2006 7:36 am

Explain the starter deal to me

Does it just stop completely or slow down?

Ryan from Ohio · Post by **Ryan from Ohio** » Sun Dec 03, 2006 9:18 am

When I was there it wouldnt even turn over.

It would engage but fall right back off.

Last I heard, Mike was going to try turning the engine over @ the crank to see if it would even turn over that way. Guess the cars been sitting unused for about a year.... So the motor, well it might of rusted up/frooze up...

Bwcad1 · Post by **Bwcad1** » Sun Dec 03, 2006 3:40 pm

i think its froze but thats just meed probably an engine swap in the future. o yea and by the way 150 @ 29hz

smoker · Post by **smoker** » Sun Dec 03, 2006 4:34 pm

29 hz? damn dude....thats damn near the brown note at that volume aint it? are you gonna tune higher to try to get louder?