Geolemon?

geolemon · Post by **geolemon** » Mon Aug 21, 2006 4:57 pm

solacedagony wrote:I know you were talking about the huge delays that you've already encountered, but do you have any general timeframe for the 12" Statements to be out?

I wish I did, I really don't want to guess at this point, because every time I have so far, I've jinxed myself!

two4fifteen · Post by **two4fifteen** » Mon Aug 21, 2006 5:19 pm

i too was wandering about vc configurations?

MobileAudio219 · Post by **MobileAudio219** » Mon Aug 21, 2006 7:11 pm

geolemon wrote:knocked a box together out of an old door and cut a hole and declared it "a port" - and then wires it up to his 1600w amp.

I usually just pull the handle out and use that has the port...

Post by **GlassWolf** » Tue Aug 22, 2006 8:24 pm

I'll be happy if the Statement 15" comes in single 4 or dual 2 ohm, and doesn't have any issue with an Orion 2250SX bridged mono @ 4 ohms, in a sealed enclosure.

My requirements are fairly simple. :)

solacedagony · Post by **solacedagony** » Wed Aug 23, 2006 8:17 am

MobileAudio219 wrote:I usually just pull the handle out and use that has the port...

And if you feel extra snazzy that day, you take the deadbolt out for dual ports! FTW!

CaptainPioneer · Post by **CaptainPioneer** » Wed Aug 23, 2006 9:04 am

heheh^^^ personallly i like using the gas cap in the rear because it has a flap on it

MobileAudio219 · Post by **MobileAudio219** » Wed Aug 23, 2006 10:51 am

solacedagony wrote:And if you feel extra snazzy that day, you take the deadbolt out for dual ports! FTW!

Nah, I usually run a single coaxial in the dead bolt hole, really helps with the sound stage....

lotas · Post by **lotas** » Wed Aug 23, 2006 11:00 am

ah yes....the good ole tweeter in the peephole?

CaptainPioneer · Post by **CaptainPioneer** » Wed Aug 23, 2006 11:00 am

yea peepholes... wait oh wait wrong kinda peephole

geolemon · Post by **geolemon** » Sun Aug 27, 2006 8:47 am

Dual 4 for now on the Response (smaller sub), although we've already prototyped a dual 2 version - but at this point I just don't have the resources to build an entire run of them also... I'd rather do one version with excellence, rather than trying to stretch our resources thin on two. Long term goal is to have both a dual 4 and a dual 2 though, as an FYI.

The big Statement sub is a dual 2 ohm.