4 channel amp question

two4fifteen · Post by **two4fifteen** » Fri Aug 04, 2006 8:43 pm

quick question about bridging a 4 channel amp. would hooking up a component set to a 4 channel amp, with each going to a bridged channel (left to the front two channels, right to the back two) , lose stereo out? in other words, would you now have a mono channel coming from both? just something i've been wandering and havent been able to find without asking.

William from NOLA · Post by **William from NOLA** » Fri Aug 04, 2006 8:47 pm

Most amps are setup to have a mono channel in the fronts and rears. Basically, just take a single RCA pair and split it where the left fills either the front or rears and the right vice versa.

That way you will use both bridged channels. Does that make sense?

two4fifteen · Post by **two4fifteen** » Fri Aug 04, 2006 8:49 pm

that does make sense. thanks.

i really should of been able to think of that myself....

Post by **GlassWolf** » Sat Aug 05, 2006 3:18 am

It's alright, we're here to think for you.

Welcome to the machine.

Robert Wollenberg · Post by **Robert Wollenberg** » Sat Aug 05, 2006 4:03 am

That's how I've been running my five channel amp. Two channels bridged to right, two bridged to left and the sub channel of course running the sub. However, as soon as I get my doors fixed (which I'll be working on again soon), I'll be running active with tweets on two channels, mids on two, and again, sub on it's channel.