Amp dimensions

audiobass10 · Post by **audiobass10** » Thu Oct 14, 2004 2:01 pm

I'm trying to build an amp rack for these Dimensions: 10-13/16 x 14-13/16 x 2-11/16" ....can someone explain to me what the dimensions mean as typed above? I can't tell by how it was typed. What is the depth/length/width?

Dustin from Huntsville · Thu Oct 14, 2004 2:42 pm

10 13/16" Wide
14 13/16" Long
2 11/16" Depth

William from NOLA · Post by **William from NOLA** » Thu Oct 14, 2004 3:05 pm

It's just like that for anything you see in that manner, FYI.

Ryan from Ohio · Post by **Ryan from Ohio** » Thu Oct 14, 2004 4:09 pm

Just a note for building amp racks. Build them as small as possible. Otherwise there is to much air to move.

Justin from Detroit1 · Thu Oct 14, 2004 4:38 pm

Just don't let any plexiglass touch the amps :) My plexi was about 1/16 of an inch from my ARC 2500XXK and the heat from playing it for 15 minutes melted the plexi. Then I touched the amp and I now have a terible burn mark on me. It was well over 150 degrees. damn amps lol.

audiobass10 · Post by **audiobass10** » Thu Oct 14, 2004 8:24 pm

Thanks for everyones replies. One question though..what does air space have to do with the amp's performance? I mean there are a lot of people who dont have amp racks. Can you explain that please

Ryan from Ohio · Post by **Ryan from Ohio** » Fri Oct 15, 2004 2:54 am

Ok you enclose the amp in a bigger more open amp rack. Add fans, it takes more fans to make the air move, it makes it harder for the air to move over and through the amp as there are easier paths it can go.

Now make it nice and tight. THe air doesnt have as many places to go, so it goes where you want it to.

I would say leave about 1/2 -3/4" above your amps- this is the more critical area. Keep the ends as short as feasible.

audiobass10 · Post by **audiobass10** » Fri Oct 15, 2004 7:08 am

Thanks for the clearing that up Ryan.

William from NOLA · Post by **William from NOLA** » Fri Oct 15, 2004 7:16 am

Whatever fans you buy, just look to find the highest cfm you can find.
A pair of 80mm fans would work well (>30 cfm each) or a single 120mm fan with 75+ cfm.

Justin from Detroit1 · Fri Oct 15, 2004 12:33 pm

You can't really use just a single fan. You need a fan moving air into the amp rack and then a fan moving the air out of the amp rack. A single fan will just blow the hot air around.