i am inspired

churchbouy · Post by **churchbouy** » Fri Jun 30, 2006 6:34 pm

ok thanks
i also 4got the mdf 4 the rings and floor, i am going for a flush mount

joeyc · Post by **joeyc** » Sat Jul 01, 2006 12:28 am

going to need more than 2 brushes probably

churchbouy · Post by **churchbouy** » Sat Jul 01, 2006 3:47 am

did some reading last night and i figured as much

churchbouy · Post by **churchbouy** » Sat Jul 01, 2006 3:48 am

which is better mixing the filler with the resin or resin then filler

smoker · Post by **smoker** » Sat Jul 01, 2006 6:30 am

pour the resing in a mixing cup then add the resin

churchbouy · Post by **churchbouy** » Sun Jul 02, 2006 5:40 pm

let me rephrase should i
a: do the compleate glassing and then do the filler eg http://www.the12volt.com/installbay/for ... 74519&PN=1 or
b: do i just do the first layer an then a layer of resin/filler mixed and brushed on

smoker · Post by **smoker** » Sun Jul 02, 2006 9:57 pm

brush resing where you are putting the fiberglass matt at and then brush on top of the matt

MobileAudio219 · Post by **MobileAudio219** » Mon Jul 03, 2006 2:38 am

Gloves, Mask? Ice water!!!!!!!!!

smoker · Post by **smoker** » Mon Jul 03, 2006 4:02 am

ice water good.....one time i was pouring resin into a glass box that i made to add some thickness to the inside and it slopped out the sub hole and went right into my shirt pocket and set my nip on fire.....not a good day when a couple minutes later my fat ass goes running through the shop tearing my shirt off screaming about my nip.......