Another Pimp my Ride on Ebay

MobileAudio219 · Post by **MobileAudio219** » Fri Jun 30, 2006 9:11 am

I dont think the imaging would be too great there, either.

What kind of truck is this?

I'd try tossing them in the doors or kicks.

CaptainPioneer · Post by **CaptainPioneer** » Fri Jun 30, 2006 9:16 am

Dodge Ram 1500 std cab... I already have 6.5" in the doors, I dont really wanna do Kicks cause i like my leg room i have... what do u think?

I am going to see if i can find my old picture of my truck with my really old set up in it it was goofy looking

MobileAudio219 · Post by **MobileAudio219** » Fri Jun 30, 2006 9:52 am

did you mean that the speakers where in the center of the door, or that they were in the center of the truck? If they are in the center of the door thats not a bad place. What kind of speakers are you running? Are they amped?

CaptainPioneer · Post by **CaptainPioneer** » Fri Jun 30, 2006 10:05 am

Here are the exact placement of the Speakers.... Door speakers are in the lower left toward the front hood.... the Rear speakers are on head level directly posted to the back of the cab just below the window.... and sorry to say, No they are not powered by an Amp

I am running Pioneer Premier 6.5" in the doors and Pioneer REV 6.5" posted on the rear of the cab...

Original placement of the speakers were 4 inch speakers used to be in the lower piller of the rear door frame basically on the ground... (Terrible for sound)...

Now what I was thinking was to take the Speakers now and do this bare with the terrible drawing here:

(Spkr)[seat

seat]openopenopen[seat

seat](Spkr)
[seat

seat] openopenopen [seat

seat]
[seat

seat] openopenopen [seat

seat]

Open aread is just blank space and the seat is where the seats would be in reference to the back view of the truck toward the rear of it. The speakers would still be posted on the back wall just all the way to the left and all the way to the right... Still on head hight if not just a little lower.

Post by **GlassWolf** » Fri Jun 30, 2006 1:56 pm

actually Chet finally showed himself doing it the right way.
sanded, adheson promoter, primer, paint, clearcoat.

CaptainPioneer · Post by **CaptainPioneer** » Sat Jul 01, 2006 4:43 pm

nice buy Isnt Chet the Electrictronics specialist the wire guy?

MobileAudio219 · Post by **MobileAudio219** » Sun Jul 02, 2006 9:41 am

GlassWolf wrote:actually Chet finally showed himself doing it the right way.
sanded, adheson promoter, primer, paint, clearcoat.

Even so, I bet it doesnt last... I've done a few radio bezel and other suck items, but door panels and consoles see alot of abuse... I'd like to see the cars a year down the road, maybe it wouldnt be as bad as I think?