hifonics bx1000d settings ???

OnYrMrk · Post by **OnYrMrk** » Wed Jun 28, 2006 10:31 am

yea, Dane is quite the funny guy. I listen to Larry the Cable guy whenever I can

CaptainPioneer · Post by **CaptainPioneer** » Wed Jun 28, 2006 10:57 am

George Carlin is Hillarious as well. I love his comedy.

the dawg · Post by **the dawg** » Wed Jun 28, 2006 12:44 pm

Getting back to the original post , settings on bx1000d, Anybody else have any ideas on these settings??

the dawg · Post by **the dawg** » Wed Jun 28, 2006 2:35 pm

Anybody have any ideas on these settings? Again, my hifonics bx1000d has subsonic filter, lowpass, bass boost, phase 0-180, voltage settings.

Bwcad1 · Post by **Bwcad1** » Wed Jun 28, 2006 6:44 pm

um i guess you didnt like my proposition? i told you if you wanted to stop by i could check it out for you

the dawg · Post by **the dawg** » Thu Jun 29, 2006 4:06 am

Yea man, that'd be cool. Where in ohio are you located at ?

Bwcad1 · Post by **Bwcad1** » Thu Jun 29, 2006 4:07 am

medina.

the dawg · Post by **the dawg** » Sat Jul 01, 2006 4:29 pm

Hooked up the bx1000d and the sub does not hit that hard. The settings on the amp are: Lowpass about 80; Subsonic at 0; Bass Boost at 0; Phase at 0; Gain(Voltage)little over halfway-about 4 volts. This is in my '97 Grand Cherokee , the sub is in a small sealed box sitting over the right wheelwell firing towards the other wheelwell(side firing). Any ideas on settings or sub placement that would make the sub hit harder and tighter???

the dawg · Post by **the dawg** » Sun Jul 02, 2006 4:39 am

Maybe a bigger box?? It is in a small sealed box about 1.0 cubes, is this big enough for a 12" type-r ??

the dawg · Post by **the dawg** » Sun Jul 02, 2006 5:45 pm

I might try building a ported box as I hear type-r's do better ported vs. sealed. However I have never built a ported box before. Any ideas where I can find some plans to build such a box??