Physically Wiring a Passive Crossover

solacedagony · Post by **solacedagony** » Thu Apr 20, 2006 6:21 am

Say this is your diagram. Do those dots mean you just solder another wire onto that point to distribute the same signal across two wires? (Referring to the dots at the SPK+ and SPK-.)

Bwcad1 · Post by **Bwcad1** » Thu Apr 20, 2006 6:24 am

it doesnt have to be that specific point just some where on that wire.

solacedagony · Post by **solacedagony** » Thu Apr 20, 2006 8:32 am

Yea, sorry, I don't think I'm wording my question correctly.
So 2 wires are coming off the input's positive and 2 wires are coming off the input's negative? Each going to the positive and negative of the mid and tweeter. Then on these wires of each way (1 to tweeter, 1 to mid) you'd wire in your caps and coils?

Robert Wollenberg · Post by **Robert Wollenberg** » Thu Apr 20, 2006 8:38 am

solacedagony · Post by **solacedagony** » Thu Apr 20, 2006 9:49 am

Ah ok, thanks guys!