jbl infinity

snyper2k2 · Post by **snyper2k2** » Mon Jan 31, 2005 4:26 pm

I have a 4 ohm Kappa perfect. It takes 350 rms. And a jbl 600.1 Whats the best way to wire it? Its in a sealed box.

just on 1 channel? 300 watts??

Justin from Detroit1 · Mon Jan 31, 2005 6:59 pm

svc or dvc

snyper2k2 · Post by **snyper2k2** » Mon Jan 31, 2005 8:57 pm

Hmm, its a 4 ohm single voice coil. Im guessing the only way is on 1 channel ehh. Since it will only give 60 at 2 ohms

ridr4lif · Post by **ridr4lif** » Mon Jan 31, 2005 9:06 pm

Isnt that jbl amp 300x1 at 4 ohms? If so, just wire the positive on the amp to the positive on the sub, and the negative on the amp to the negative on the sub. Then the sub will get 300 watts rms which should make that sub move pretty good.
TEDD

snyper2k2 · Post by **snyper2k2** » Sat Feb 05, 2005 8:04 pm

Yeah. it has 2 negs and 2 positives for the sub connections. And 2 + rca inputs, and 2 - rca Inputs.

ridr4lif · Post by **ridr4lif** » Sun Feb 06, 2005 12:10 am

Do you have the owners manual for this amp? If not, i think Will has the same amp and can probably help you out. I kno for a fact that you will want to get rca splitters so u can run signal to all the rca inputs.
TEDD