Ok, I was asking this before but I never had pictures... The question again is, How do I get these speakers out of there? The vehicle is a 2002 Nissan Sentra.
You will probably have to start with the panels around that back panel. Such as the C pillars or if you fold the seats down, you may have some screws on the panels right behind that.
I'd check with a Nissan forum. They'd usually know or have something right there for you to see.
Wlecome to fun. I advise you highly to make your mind up before proceeding and whatever you put in there, thats it. Lot of work!
Remove the back seat. Chances are you will have to remove the bench part first then the back rest. Then remove the plastic panels in the back. When you get that done the deck card will need to be slightly folded in the center while lifting. Be careful not to bend it to much, just enough.
Assembly is just as much a pain. Especially to get it all back in correctly and make it look untouched.
When you do this, I highly advise putting some grille cloth over the speakers. That way the suns UV Rays wont mess with them. Cheap insurance also. Keeps thiefs guessing...
Hmmm... sounds like a huge pain in the ass lol.. Maybe I'll just craft myself some fiberglass kick panels and deal with the front stage and forget the rear.
Vindicate wrote:Hmmm... sounds like a huge pain in the ass lol.. Maybe I'll just craft myself some fiberglass kick panels and deal with the front stage and forget the rear.
I think fiberglassing would be more work. Both are a pain in the ass lol
I would agree on making the front stage better. It helps.
Are you sure you just can't un clip that plastic covering the speaker? Or just pop out the metal grill? If could could get that off, then you should be able to unscrew them right out.
♠ Mateo ♠
80 pounds of Titanium
Proud Member of Team Wolfpack Audio