okay sine i have no subs, no amps, an unfinshed amprack, and some unfinished boxes....
im finally giong to paint my sail panels. how do i properly mix the bondo and hardener? first of all.. its kind of chunky-ish if i remeber correctly in the can, and it was a pain to mix last time... i always thought bondo was smoother to mix.. but anyway, i need some help. last time it didn't dry.
edit: temp today will be like... 60s-70s i think.
edit2: if you have any ideas for fiberglass projects for my saturn, chirp in!
if its chunky throw it out....it may have sat for too long or may have gotten some hardner in it.......i doubt it got hardner in it because the whole can may have hard3entd if it did but itis no good regardless if its chuncky
if the scratches arnt bad just use a primer cause your going to have to primer it anyways cause mdf is a sponge and youll use way way too much paint if you dont seal it with primer. also bondo is a sponge too so you have to prime over that.
its going to be warm this weekend.. i weant to try and tackle some fiberglass work but i don't know what to do. i could always make some boxes for my subs with fiberglass...
bondo wont stick to plastic unless you have a speical kind so id just use primer but make sure its preped right. and make sure you wear rubber gloves when you fiberglass.
