problems

Darthness · Post by **Darthness** » Mon Jan 09, 2006 9:11 am

welcome to Saturn.

Darthness · Post by **Darthness** » Fri Jan 13, 2006 11:19 am

Yeah well i bought a screw-extractor bit today.. bu ti can't actually get it down there. its in a tight spot... any suggestion? this scrw has to come out

edit: instead of screw, try about 4 of em. 2 on each door that don't want to come loose.

Darthness · Post by **Darthness** » Fri Jan 13, 2006 11:28 am

http://i10.photobucket.com/albums/a131/ ... handle.jpg

^ thise are the screws...

sinister audio · Post by **sinister audio** » Fri Jan 13, 2006 11:34 am

just take a good #2 phillips and put it on there and tap it down itll knock some of that crap out of there and make sure you press down hard when your taking it out.

Bwcad1 · Post by **Bwcad1** » Fri Jan 13, 2006 11:51 am

well you could always drill it out but y dont you just get an extension on your bit?

Darthness · Post by **Darthness** » Fri Jan 13, 2006 1:36 pm

so apparently i don't know how to use a screw driver...

my dad went out a few minutes ago and unscrewed them like nothing was there.

Bwcad1 · Post by **Bwcad1** » Fri Jan 13, 2006 1:50 pm

lol its all a good time! sometimes it just takes a tad bit more skill then you have!