Anyone know???

musclestang · Post by **musclestang** » Wed Jan 04, 2006 5:02 pm

I'm trying to add keyless entry to a 2006 Ford Focus, but they have one cable that controls the lock and unlock, and also the door handle . Does anyone know how to add keyless entry to this vehical??? Any info on this matter is greatly appreciated. Thanks, Musclestang

William from NOLA · Post by **William from NOLA** » Wed Jan 04, 2006 6:11 pm

I would try a Focus specific forum if no one can help you here.

smoker · Post by **smoker** » Wed Jan 04, 2006 6:38 pm

im assuming that you dont have electric locks at all and that you are going to need to add an actuator like this

http://www.microalarm.com/pdf/catalog.pdf

Post by **GlassWolf** » Thu Jan 05, 2006 3:04 am

if the doors are electrical and not vacuum operated, you just need to wire into the existing relays that control the door operation to send the pulses to the locks.
the12volt.com has a lot of data on wiring keyless entry systems for alarms.

musclestang · Post by **musclestang** » Thu Jan 05, 2006 8:52 pm

I have actuators, but the problem is that there is only one cable that controls both lock/unlock, and door handle. It's not two seperate rods. I'm trying too see if there is a way to hook up the actuator and still be able to open the door??? Thanks Musclestang