Attention all members!
Have a cool ride? Then show it off on our website! All vehicles welcome!

Wiring Questions

Post all your general car audio questions here.
Robert Wollenberg
Posts: 1386
Joined: Mon Sep 19, 2005 4:45 am
Location: Abilene, Texas

Post by Robert Wollenberg »

I was trying to find the current draw of a headrest monitor. No luck. But I can't imagine it's very much. You could probably run several off a 16 awg wire with a 5 amp fuse and not have problems. It would be pretty easy to figure out if I knew what their current draw was.
smoker
Master of My Domain
Posts: 4126
Joined: Tue Mar 15, 2005 9:00 am
Location: florence, ky
Contact:

Post by smoker »

yea i dont know off the top of my head but they dont need much.....
stephensmia
Senior Member
Posts: 196
Joined: Sat Sep 17, 2005 9:45 am
Location: Springfield, OH

Post by stephensmia »

This is all th info I could get on the moniters
Operating Temperature 0°~60°C
-Operating Humidity 20%~85%
-Operating Voltage DC+12V
-Power Consumption <10W
Robert Wollenberg
Posts: 1386
Joined: Mon Sep 19, 2005 4:45 am
Location: Abilene, Texas

Post by Robert Wollenberg »

So, that should be less than one amp of current draw by my math. Does anybody disagree? That being the case, you could easily run several montors off a smaller gage wire with minimal fusing. A five amp fuse should be adequate for even 5 monitors. As for wire size, You could safely use what ever small gage speaker wire you have laying around to extend your power wires as far as you needed to.
stephensmia
Senior Member
Posts: 196
Joined: Sat Sep 17, 2005 9:45 am
Location: Springfield, OH

Post by stephensmia »

hey guys this is the component set and amp i might be getting what do you think.

Blaupunkt

Velocity Series 5.25" Components
Suggested Retail Price.....$189.95
Type 2 way Power Continuous (W rms) 100
Power Peak (W max) 200
Sensitivity (dB 2.83V / 1m) 90
Frequency Response (Hz) 70 - 23,000
Magnet Weight (oz) 11.3
Cone Material Silk Surround Material Rubber

Amp
ProComponent Series 2x60W Amplifier
Suggested Retail Price.....$129.95
Stable to 2 Ohm loads for flexible integration with any speaker/subwoofer setup
• Crossovers continuously variable from 50 – 250 Hz (both high-pass and low-pass)
• Variable bass boost control for 0-12 dB gain
• Massive gold-plated terminals for high current handling capabilities
• Reinforced Class AB design ensures solid performance and long-term reliability
• Large heatsinks to prevent thermal overload
Post Reply