pitmer(?) arm, two ball joints, price quote?

lotas · Post by **lotas** » Mon Nov 21, 2005 3:17 pm

How much should it be to replace two ball joints, and something like a pitmer arm and lever? The car is a 1997 Blazer. The quote was $750 parts and labor. Is that high or low? thanks guys.

ridr4lif · Post by **ridr4lif** » Mon Nov 21, 2005 3:29 pm

Pitman arm.

But yea, that sounds just about right if it were to come into my shop, but we are 90 bux an hour. I would say it should be closer to 650ish. Either way, its a pain in the ass job and i would have the shop do it, considering they are basically pulling the whole front end apart.

You might wanna unload that problem (Blazer) to someone else so you dont have to deal with it anymore

sinister audio · Post by **sinister audio** » Mon Nov 21, 2005 4:13 pm

ya they arnt very fun and it sucks doing on the ground. i would do it my self but i have been turning wrenches since i was a little kid.