-Another Wiring Question-

audiocr381ve · Post by **audiocr381ve** » Thu Sep 29, 2005 5:01 pm

What ohm sub would I need to buy, if I wanted 3 subs, running off a JBL bp600.1? What would work?

Post by **GlassWolf** » Thu Sep 29, 2005 7:01 pm

three 6 ohm subs, or three dual 3 ohm coil subs.
either way you'll get a 2 ohm load with three subs on a mono amp.

audiocr381ve · Post by **audiocr381ve** » Fri Sep 30, 2005 3:10 pm

I haven't seen much 6 ohm or DVC 3 ohm subs LOL.

Would it be easier to run 4 subs, as far as FINDING subs?

Bwcad1 · Post by **Bwcad1** » Fri Sep 30, 2005 3:45 pm

audiocr381ve · Post by **audiocr381ve** » Fri Sep 30, 2005 4:51 pm

What OHM sub if I wanted 4 of them on the bp600.1?

audiocr381ve · Post by **audiocr381ve** » Sat Oct 01, 2005 7:34 am

What ohm subs If I needed 4 of them !!

Post by **GlassWolf** » Sat Oct 01, 2005 8:39 am

to get a 2 ohm load on a mono amp?
four 2 ohm SVC subs, or four 4 ohm DVC subs.
...depending on what's offered by that make and model of sub you choose.
you could also use four 8 ohm SVC subs in parallel.

Post by **GlassWolf** » Sat Oct 01, 2005 8:39 am

note four subs on a 600.1 amp equals 150wRMS each.. not a lot of juice

audiocr381ve · Post by **audiocr381ve** » Sun Oct 02, 2005 5:55 am

Tell me this kiki, would it be better to buy two 300 watt 8's, or four 150 watt 8's. Wouldn't it be the same?

I'm going with 8's due to limited room in the new truck. I haven't seen anyone throw some 10's in, I don't know how it would work.

Post by **GlassWolf** » Sun Oct 02, 2005 8:40 am

yeah, if the subs aren't reaching peak output then yes two of the same subs with twice the power will have the same output.