Attention all members!
Have a cool ride? Then show it off on our website! All vehicles welcome!

Orion 2150GX Old School Need Major Help!

All questions related to amplifier installation and troubleshooting.
sidewayzgt23
Junior Member
Posts: 14
Joined: Wed Jul 27, 2005 8:20 pm

Post by sidewayzgt23 »

Here are the specs on my subwoofer.. What do you suggest is the best way to run this amp.. I see that it is dual 4ohm and by what you said before, I cannot bridge the amp.. How would you run 1 channel and get the full 300 watts? Is there a specific crossover or eq that I need in order to really reap the benefits? Please let me know how you would do the installation if it were your amp and wanted to get the most power and bass out of it?
General Features: Dual Voice-Coil
Cone Material: Kevlar Reinforced Pulp
Cone Style: Cone
Diameter: 12 in
Nominal Impedance: 4 ohm(s)
Nominal Input Power Rating: 500 W
Sensitivity: 87 dB
Speaker Configuration: Single Speaker
Satellite Max Frequency Response: 500 Hz
Satellite Min Frequency Response: 24 Hz
Maximum Input Power Rating: 1500 W
sinister audio
Master of My Domain
Posts: 2562
Joined: Sat Mar 19, 2005 9:00 am
Location: Watertown, South Dakota
Contact:

Post by sinister audio »

you will get 300 watts per channel at 2 ohms and 150 per channel at 4ohms, you already have the power you need for it on 1 channel and leave the other one open or get another sub and have 2 ran off of it. if you get an aftermarket deck you dont need a crossover/eq because now 90% have most of the stuff you need.
sidewayzgt23
Junior Member
Posts: 14
Joined: Wed Jul 27, 2005 8:20 pm

Post by sidewayzgt23 »

I have no choice but to use my factory headunit because it is a leased car.. Will my sub work at 2 ohm or 4 ohm? I am running a line out converter from my Monsoon amp that comes stock with the Jetta.. How would I just run 1 channel on this amp? Do I just plug 1 rca in from the converter or both and just hook the speaker to 1 side. Or do I hook left and right to the speaker in a negative-negative, positive,positive configuration? What kind of crossover should I use for I have no choice?
sinister audio
Master of My Domain
Posts: 2562
Joined: Sat Mar 19, 2005 9:00 am
Location: Watertown, South Dakota
Contact:

Post by sinister audio »

you can throw an aftermarket deck into a leasedcar you just use an install wireing harness so you dont hack it up and just take it back out when the lease is up. the sub 2ohm. you use a pair of rca's a left and right.
sidewayzgt23
Junior Member
Posts: 14
Joined: Wed Jul 27, 2005 8:20 pm

Post by sidewayzgt23 »

I do not have the money to get a new head unit.. I know that it would make it a lot easier.. Please let me know with the stock unit? Sorry for so many ?'s
JeremyC
Master of My Domain
Posts: 2329
Joined: Sat Jan 15, 2005 4:13 am
Location: Oklahoma

Post by JeremyC »

sidewayzgt23 wrote:I am running a line out converter from my Monsoon amp that comes stock with the Jetta..

I know you don't want to hear this, but you really really need an aftermarket deck. What your doing it tring to take a poorly amplified siginal, tune it down with a line out converter, and then reamplify it. Its not a good combo, trust us on this.

Here is a good analogy for you.
take a pile of poop, cut it in half, and add water. You still have poop, but now its runny. Probably not the result you were looking for.

Honestly an aftermarket deck will save you money, and give you way better results. Any time you are dealing with a car with factory amps (the monson system) your always better of with an aftermarket deck.
User avatar
GlassWolf
Master of My Domain
Posts: 6725
Joined: Thu Oct 07, 2004 4:00 am
Location: Columbia, SC
Contact:

Post by GlassWolf »

simple fact is you can't run a single 4 ohm DVC sub on that Orion amp without buying a low pass filter, and without running the amp at 4 ohms stereo.
the amp isn't 2 ohm stable when bridged, and you can't get two ohms stereo from a 4 ohm DVC sub on a 2 channel amp.

you just bought the wrong gear. you need a dual 2 ohm sub in order to use that amp, or you need to go buy a class D mono amp for that sub you have now.

end of story.
Image
GlassWolf (aka KikiTheCat)
moderator-administrator
User avatar
GlassWolf
Master of My Domain
Posts: 6725
Joined: Thu Oct 07, 2004 4:00 am
Location: Columbia, SC
Contact:

Post by GlassWolf »

by the way, buying a modern class D mono amp, the amp will have its own low pass crossover built into it, unlike the old Orion.

any way you look at it you need to go spend some money to get this all to work.
Image
GlassWolf (aka KikiTheCat)
moderator-administrator
User avatar
Chris from Washington
Posts: 4672
Joined: Sat Oct 02, 2004 8:00 am
Location: Washington
Contact:

Post by Chris from Washington »

JeremyC wrote:
Here is a good analogy for you.
take a pile of poop, cut it in half, and add water. You still have poop, but now its runny. Probably not the result you were looking for.

:bow Best analogy ever (lol)
JeremyC
Master of My Domain
Posts: 2329
Joined: Sat Jan 15, 2005 4:13 am
Location: Oklahoma

Post by JeremyC »

Yeah I had just finished a 13 hour work day, so I was pretty loopy when I came up with that. But I knew you guys would love it.
Post Reply