cerwinvagas 12 problem

qlc1964 · Post by **qlc1964** » Wed Aug 05, 2009 7:17 pm

like captain said no matter which amp i hook it to this sub has a

lower out put than the other one. both kenwoods are bridged.
kac-7203 and kac-7252 now both has the same specs the 7203.

i am using the lp on both amps at 100 hz and gains the same.

is a 1yr newer model than the other one.

and i do value all yha comments & suggestions

Bwcad1 · Post by **Bwcad1** » Wed Aug 05, 2009 7:37 pm

lol im not even gonna touch this anymore. Sell me your subs for 50 bucks.

CaptainPioneer · Post by **CaptainPioneer** » Thu Aug 06, 2009 5:19 am

I would say that taps it... If they are both set up exactly the same and same output @ same ohm config, same everything... It has to be the sub... there could be something obstructing the cone from moving or something could be rubbing on the motor.... Who knows maybe one of his VC's is misaligned?

Bwcad1 · Post by **Bwcad1** » Thu Aug 06, 2009 5:22 am

I still don't think its the subs but what do i know

, the chances of that happening are way to small. The simple solution isn't always the easiest. Move both cones with your hand do they feel the same with in reason?

Tim · Post by **Tim** » Thu Aug 06, 2009 1:10 pm

the only thing i can think of, and this has already ben mentioned, is they are cross wired. I got a buddy at work, that had similar problem, and he had cross wired the subs. there just aint that many things that could be wrong.

I mean he has pretty much exhausted all our ideas.

Tim

qlc1964 · Post by **qlc1964** » Tue Mar 16, 2010 9:06 pm

i'm back!!! still been having the sub problem started last week.
the sub plays normal for a while then it goes lower went through

the proccess either it's the left rca is bad or it's the sub left output coming out the radio . i will check this today. i hope it's the rca

qlc1964 · Post by **qlc1964** » Sun Mar 21, 2010 8:44 pm

it was the cheap walmart scoshe rca for the subs now their fine.

Post by **GlassWolf** » Mon Mar 22, 2010 6:06 am

first thing I would check is the amplifier gain settings. It sounds like the amp(s) is/are clipping.

turn bass boost to zero, set gain no higher than one-quarter turn up, set phase to zero, set XO to 60Hz, and set Q (slope) to 18dB

see how that works.

If the amps aren't loud enough with those settings, you need to look for larger amplifiers.