Screw and glue...

Bwcad1 · Post by **Bwcad1** » Thu Jan 29, 2009 8:09 pm

i use a circular saw and a straight edge. Get some deckmate's if your gonna use screw's i never use them anymore unless i need to pull something together. Staples and Glue have always done great for me. but i use 1-5/8's staples .25 crown. and titebond plus i seal the interior with liquid nails HEAVY DUTY or PL400

MobileAudio219 · Post by **MobileAudio219** » Thu Jan 29, 2009 10:07 pm

Bwcad1 wrote:i use a circular saw and a straight edge. Get some deckmate's if your gonna use screw's i never use them anymore unless i need to pull something together. Staples and Glue have always done great for me. but i use 1-5/8's staples .25 crown. and titebond plus i seal the interior with liquid nails HEAVY DUTY or PL400

I seal with liquid nails too!!!

cargodz · Post by **cargodz** » Fri Jan 30, 2009 5:19 am

Decking screws, Glue, Silicone, PL, or Glass (or combinations of)... Screws at approx. 6 inches apart (closer on corners). As for cutting I've been known to use all: Table saw, Circular saw, Jig saw, Router... Heck I can even do (and have done) precision cuts with a saws all... The Grinder, sander, and Dremel also come in very handy.

falkenbd · Post by **falkenbd** » Fri Jan 30, 2009 12:57 pm

delta unisaw ftw

i've put together cabinets with no gaps. still use pocket screws for extra strength.

MobileAudio219 · Post by **MobileAudio219** » Fri Jan 30, 2009 1:59 pm

falkenbd wrote:delta unisaw ftw

i've put together cabinets with no gaps. still use pocket screws for extra strength.

Take 50 bucks shipped for the saw?

Tim · Post by **Tim** » Sat Jan 31, 2009 7:41 pm

I use a table saw, 100.00 entry level delta from Lowe's. I usually go about 4-6" apart and predrill and countersink the screws, I also glue the joints. I usually seal the box with clear silicone, but I have used liquid nails before.

Now that I have a air compressor an nail gun I will probably go with glue/brad nails.

The first couple boxes I made I used a circle saw and a jig saw.

Tim

CaptainPioneer · Post by **CaptainPioneer** » Mon Feb 02, 2009 5:37 am

I wish I had a brad nailer... I have a Porter Cable Finish nailer... meh... its so not cut out for boxes...

Bwcad1 · Post by **Bwcad1** » Mon Feb 02, 2009 6:00 am

CaptainPioneer wrote:I wish I had a brad nailer... I have a Porter Cable Finish nailer... meh... its so not cut out for boxes...

Go to walmart pick up the 25 dollar campbell hausfeld 1/4 crown stapler works great for the price. after a few years go buy another.

falkenbd · Post by **falkenbd** » Mon Feb 02, 2009 8:09 am

MobileAudio219 wrote:Take 1200 bucks shipped for the saw?

Sure... (its not mine anyway)

Car Audio Central - Ultimate Car Audio Forum and Community

Screw and glue...

How do you assembly your enclosures...