by Ryan from Ohio » Sun Dec 04, 2005 7:17 pm
You will want to take out the rear seat.
GM Cars... Usually two Torx type screws or two pull tabs on the bench seat part. Like where it meats the floor carpet. Take them two off pull the bench seat out. Then there are like 203 nuts holding the backrest on. Take off and lift UP!.
Next is the plastic that touches the rear deck. Remove ONE side.
THe deck should come off with a bit of fight, fold GENTLY. Bend it in a few spots but no TIGHT bends...
Make sure you have everything you need and only do this once as its a pain in the arse!
You will want to take out the rear seat.
GM Cars... Usually two Torx type screws or two pull tabs on the bench seat part. Like where it meats the floor carpet. Take them two off pull the bench seat out. Then there are like 203 nuts holding the backrest on. Take off and lift UP!.
Next is the plastic that touches the rear deck. Remove ONE side.
THe deck should come off with a bit of fight, fold GENTLY. Bend it in a few spots but no TIGHT bends...
Make sure you have everything you need and only do this once as its a pain in the arse!