Car Audio Central - Ultimate Car Audio Forum and Community

by **smoker** » Mon Jul 03, 2006 4:02 am

ice water good.....one time i was pouring resin into a glass box that i made to add some thickness to the inside and it slopped out the sub hole and went right into my shirt pocket and set my nip on fire.....not a good day when a couple minutes later my fat ass goes running through the shop tearing my shirt off screaming about my nip.......

by **MobileAudio219** » Mon Jul 03, 2006 2:38 am

Gloves, Mask? Ice water!!!!!!!!!

by **smoker** » Sun Jul 02, 2006 9:57 pm

brush resing where you are putting the fiberglass matt at and then brush on top of the matt

by **churchbouy** » Sun Jul 02, 2006 5:40 pm

let me rephrase should i
a: do the compleate glassing and then do the filler eg http://www.the12volt.com/installbay/for ... 74519&PN=1 or
b: do i just do the first layer an then a layer of resin/filler mixed and brushed on

by **smoker** » Sat Jul 01, 2006 6:30 am

pour the resing in a mixing cup then add the resin

by **churchbouy** » Sat Jul 01, 2006 3:48 am

which is better mixing the filler with the resin or resin then filler

by **churchbouy** » Sat Jul 01, 2006 3:47 am

did some reading last night and i figured as much

by **joeyc** » Sat Jul 01, 2006 12:28 am

going to need more than 2 brushes probably

by **churchbouy** » Fri Jun 30, 2006 6:34 pm

ok thanks
i also 4got the mdf 4 the rings and floor, i am going for a flush mount

by **smoker** » Fri Jun 30, 2006 5:50 pm

mdf for making rings to mount the speakers to

cups to mix resin in

sticks to stir resin

rubber gloves

sandpaper and lots of it

you probably dont need the fiberglass mat for this project just an old t-shirt and a couple or three coats or resin should do it....

Car Audio Central - Ultimate Car Audio Forum and Community

i am inspired

Post a reply

Expand view Topic review: i am inspired

fiberglass