Attention all members!
Have a cool ride? Then show it off on our website! All vehicles welcome!

Cracked RE

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:awesome: :argh :ditto :inout :words :bow :cheers: :bigwink: :fing02: :sad017: :scorp: :o :D ;) :p :unwell028 :tongue017 :thumbsup :surprised :sm29: :angry011: :angry015: :angry012: :nono: :angry010: :nono :banghead :mad: :dif :angry :CRZ_13: :eek: :confused: :confused0 :confused :( :sad: :cool: :dance :mecry: :jesterlol :embarrass :flame: :doh :evil019: :evil001: :rolleyes: :sub:
View more smilies
BBCode is ON
[img] is ON
[url] is ON
Smilies are ON
Topic review
   

Expand view Topic review: Cracked RE

by Ryan from Ohio » Sun Jun 05, 2005 5:40 am

I doubt the crack was from inferior material...

But I would give them a call and see. Maybe tell them it one you purchased? Dunno...

by High Society » Sat Jun 04, 2005 9:21 pm

Well the one that's cracked wasn’t bought from RE. I got it off e-bay, from that audio shop that was going out off business. It is brand new tho, still has the masking tape over the vent hole, so I don't think it's under warranty since it was won on ebay??

by GlassWolf » Sat Jun 04, 2005 1:23 pm

those REs are fairly new aren't they?
send it back to RE and have them repair it under warranty before you go messing with a home repair.

by Ryan from Ohio » Sat Jun 04, 2005 9:30 am

Use good glue=better results, better adhesion and more strength.

CA Glue from Hobby Stores is the BEST to use- DONT GET GEL!

Why just the back?

Well first is obvious- looks. The patch would make the sub look like crap.

The glue should have enough adhesion to hold the cloth tight to the cone and make the cloth strong.

Its the only way to fix this ;)

by High Society » Sat Jun 04, 2005 6:19 am

It will hold up even if the front side isn't fixed like that then? How come any kind of super glue wont work?? If I didn’t find this crack and I installed it and started playing it, would it have gotten worse?

by Ryan from Ohio » Sat Jun 04, 2005 6:04 am

Well I got the fix for you. Same thing I did to these 10" ARCs.

Goto WAL Mart and get some fiberglass cloth and find some quality CA/Super Glue- not the cheap crap!

First put masking tape on the inside of the cone (where the logo is) so the glue doesnt seep thru the crack.

Cut a small piece of cloth that extends about 1-2" or so wide and to the needed length.

Lay cloth on back side of cone. Grab a few nice long tooth picks. Start from the lower center- drip a drop of glue- it will soak and sread. Blow on it a bit to aid in this. Give it a 30-i minute between drops while blowing on it or use a fan. DO this slowly until the whole piece of cloth is covered while using the toohpicks to press and hold the cloth down.

You will see when the cloth is covered...

Cracked RE

by High Society » Sat Jun 04, 2005 5:39 am

Last night I found a crack on one of my 8's, it extends from the tip of the surround till the edge of the dust cap. It's really hard to see it since I put the crack at level with each other, but I was wondering how big of a problem this is, and how can I fix it?

Top