by 71buickfreak » Thu Jun 02, 2005 4:05 pm
theres a cool trick you can use to clean up those cut outs where you have the coners exposed (It looks like they are in the pic, it might not be) you take a different colored vinyl (for accent) and a piece of thin card stock. you lay the good side of the vinyl against the inner edge of the cut out and place the thin strip of cardstock on the inside, staple it in place, then pull back the vinyl and staple it to the back side of the panel. do this all the way around the cut out and you end up with a nice accent trim that looks trick. or you could just use a heat gun and really stretch the vinyl till it clears the corner. gotta be careful so you don't burn and melt the vinyl.
theres a cool trick you can use to clean up those cut outs where you have the coners exposed (It looks like they are in the pic, it might not be) you take a different colored vinyl (for accent) and a piece of thin card stock. you lay the good side of the vinyl against the inner edge of the cut out and place the thin strip of cardstock on the inside, staple it in place, then pull back the vinyl and staple it to the back side of the panel. do this all the way around the cut out and you end up with a nice accent trim that looks trick. or you could just use a heat gun and really stretch the vinyl till it clears the corner. gotta be careful so you don't burn and melt the vinyl.