by DJ_Evel » Mon Nov 05, 2007 9:19 pm
OK I figured it out and you may find this interesting. The amp was mounted on the box and the vibration over time loosened the rear plate on the amp. The terminals were shorting inside on the rear plate and causing the amp to go into protective mode.
Solution: I used a lexan plate. Drilled vent holes in a box pattern sort of arangement for a vent, which I also mounted a fan controlled manualy or by a thermostat too. (I will set my thermostat eventually lol). Put in some little LEDs, flipped it over and used big rubber stoppers to mount it back to the box. Problem solved.
All said in done. its a little sloppy but people can litterally hear me coming from a good distance.
Thanks again guys
OK I figured it out and you may find this interesting. The amp was mounted on the box and the vibration over time loosened the rear plate on the amp. The terminals were shorting inside on the rear plate and causing the amp to go into protective mode.
Solution: I used a lexan plate. Drilled vent holes in a box pattern sort of arangement for a vent, which I also mounted a fan controlled manualy or by a thermostat too. (I will set my thermostat eventually lol). Put in some little LEDs, flipped it over and used big rubber stoppers to mount it back to the box. Problem solved.
All said in done. its a little sloppy but people can litterally hear me coming from a good distance.
Thanks again guys