Page 1 of 1
ed nine.1
Posted: Fri Nov 23, 2007 6:30 pm
by cblaze
real watts any one benched one of them,there rated at 12.5 volts so its gotta do some pretty good numbers,and how well they hold up.ive read they aree good and then they fail repeatedly,the ppl that have them or have used them give me some feedback,im not a noob just like to spend my money well
Posted: Tue Dec 11, 2007 7:48 pm
by cblaze
nobody?would about 1500 be right?
Posted: Wed Dec 12, 2007 3:56 am
by Ryan from Ohio
WRMS = Amps (max draw(fuse sizes)) x Voltage
wrms = 130 x 13.8
wrms = 1794
Efficency = 64%
1794 x .64 = 1148
Thats the RMS. Thats also per eD specs pulled from their page. Since the fuses dont blow right away, it may be possible to get a bit more power but its very brief.
Posted: Wed Dec 12, 2007 5:08 am
by Bwcad1
Ryan from Ohio wrote:WRMS = Amps (max draw(fuse sizes)) x Voltage
wrms = 130 x 13.8
wrms = 1794
Efficency = 64%
1794 x .64 = 1148
Thats the RMS. Thats also per eD specs pulled from their page. Since the fuses dont blow right away, it may be possible to get a bit more power but its very brief.
very very correct. s=i would say after impedance rise and in a daily box on a daily electrical system you would see around 800 watts.
Posted: Wed Dec 12, 2007 6:58 am
by cblaze
what ur sayign the amp will onl put out 800 watts?
Posted: Wed Dec 12, 2007 7:08 am
by Robert Wollenberg
What he's saying is that without beefing up your electrical system, considring the impedence curve of the driver, and that you're playing music rather then burping a single frequency, you're probaby only going to use about 800 watts of the potentially available 1148.
Posted: Wed Dec 12, 2007 7:09 am
by cblaze
oh i got you
Posted: Mon Jan 14, 2008 9:20 pm
by headbussaboi
They were benched to do about 1400 or so on 14.4 volts though.
Posted: Mon Jan 14, 2008 10:15 pm
by Robert Wollenberg
sure, benched with a programmed input signal not music. You going to drive around and listen to a 1k test tone cranked as loud as it goes? I doubt it.
Posted: Tue Jan 15, 2008 3:52 am
by Ryan from Ohio
headbussaboi wrote:They were benched to do about 1400 or so on 14.4 volts though.
Given the specs and fuses its impossible unless they were measuring output before fuses blew, or replaced the fuses with larger.
The laws of electric are set, there is no getting around it.
eD will spoon feed bullshit to anyone willing to listen.