Car Audio Central - Ultimate Car Audio Forum and Community

I could use some help figuring out the best way to wire my set-up. I have 1 Soundstream Van Gogh VGA500.4 amp with the specs listed below.

RMS @ 4 OHMS: 125W x 4 CH
RMS @ 2 OHMS: 250W x 4 CH·
RMS BRIDGED POWER @ 4 OHMS: 500W x 2 CH


I have 4 8ohm (100rms / 200max) midbass speakers and 2 8 ohm (100rms / 200max) compression horns. Can you help me figure out the best way to wire them to my amp to get the most watts out?

Thanks for your help.

tmorefi wrote:I could use some help figuring out the best way to wire my set-up. I have 1 Soundstream Van Gogh VGA500.4 amp with the specs listed below.

RMS @ 4 OHMS: 125W x 4 CH
RMS @ 2 OHMS: 250W x 4 CH·
RMS BRIDGED POWER @ 4 OHMS: 500W x 2 CH


I have 4 8ohm (100rms / 200max) midbass speakers and 2 8 ohm (100rms / 200max) compression horns. Can you help me figure out the best way to wire them to my amp to get the most watts out?

Thanks for your help.

Probably bridged to 2 channels with everything in parallel.

You could also try mids on 2 channels, tweets on 2 channels.