Car Audio Central - Ultimate Car Audio Forum and Community

Posted: **Sat Feb 12, 2005 6:38 am**

This review will be updated as I progress.

I got the sub in this week from Marshall, quick shipper!

Anyhow I got it out of the box and had a look. The sub looks realy nice for $77. It appears to be built nice and solid. I do not see excess glue all over the place like I did with my Elemental Designs sub. One thing I noted is the size of the tinsel lead. It seems rather large and stiff for this type of sub....

More to come.

THis sub will be tested in a 1.5 cubed tuned to 28 Hz and its reccomended 1 cubed sealed enclosure. The sealed will probably be the used enclsure. THis will be going in a Chrysler Cirrus of a friends.

Posted: **Sat Feb 12, 2005 11:41 am**

Posted: **Sat Feb 12, 2005 1:08 pm**

Yea Marshall's awesome..you'll get nothin but great customer service from him..I'm sure you'll enjoy the sub. I'm interested to see how it sounds sealed vs. ported.

Posted: **Sat Feb 12, 2005 1:12 pm**

Yea Marshall's awesome. You can expect nothing less than great customer service from him. I bet you'll really enjoy that RE12..i'm interested to see how it does ported vs. sealed.

Posted: **Tue Mar 01, 2005 3:05 pm**

Well sub #1 is complete.

The sub is in a 1.075 Cubic foot sealed enclosure. This box/sub combo will be used in a van with 200 WRMS going to it. Im sure it will be more than adequate.

The box is sealed very well except for the terminal cup. Im having a hard time getting it to seal properly. The buyer specified I must have one, I usually dont use them for this reason!

I dont happen to have exact measurements on hand, but the raised section is 4" off the floor (when put up properly). I believe the square on the inside is 13x13X 12 but will check into it for thoose asking.

Posted: **Sun Mar 06, 2005 12:21 am**

particle board...? or do my eyes decieve me?

Posted: **Wed Mar 09, 2005 7:36 am**

Looks liek particleboard. No big deal, really.

Posted: **Wed Mar 09, 2005 8:40 am**

Yes it is particle board, 5/8's at that.

Pffft its only a 12" RE series. 12 mm single way xmax... 1.075 SEALED

Its fine

Posted: **Wed Mar 09, 2005 9:33 am**

Thats just too thin and too cheap for any subwoofer box... No reason to skimp a box just because you don't think the woofer is capable, the RE should be loud enough to require .75" MDF... i mean hell, might as well have went with a prefab cheapy :P

Posted: **Wed Mar 09, 2005 10:27 am**

is that a downfiring box Ryan?

Car Audio Central - Ultimate Car Audio Forum and Community

Resonant Engineering RE 12"

Resonant Engineering RE 12"