Page 1 of 1
jbl infinity
Posted: Mon Jan 31, 2005 4:26 pm
by snyper2k2
I have a 4 ohm Kappa perfect. It takes 350 rms. And a jbl 600.1 Whats the best way to wire it? Its in a sealed box.
just on 1 channel? 300 watts??
Posted: Mon Jan 31, 2005 6:59 pm
by Justin from Detroit1
svc or dvc
infinity
Posted: Mon Jan 31, 2005 8:57 pm
by snyper2k2
Hmm, its a 4 ohm single voice coil. Im guessing the only way is on 1 channel ehh. Since it will only give 60 at 2 ohms
Posted: Mon Jan 31, 2005 9:06 pm
by ridr4lif
Isnt that jbl amp 300x1 at 4 ohms? If so, just wire the positive on the amp to the positive on the sub, and the negative on the amp to the negative on the sub. Then the sub will get 300 watts rms which should make that sub move pretty good.
TEDD
Posted: Sat Feb 05, 2005 8:04 pm
by snyper2k2
Yeah. it has 2 negs and 2 positives for the sub connections. And 2 + rca inputs, and 2 - rca Inputs.
Posted: Sun Feb 06, 2005 12:10 am
by ridr4lif
Do you have the owners manual for this amp? If not, i think Will has the same amp and can probably help you out. I kno for a fact that you will want to get rca splitters so u can run signal to all the rca inputs.
TEDD