Page 1 of 3
multipe remote's
Posted: Wed Sep 06, 2006 1:05 pm
by two4fifteen
is there a general rule of how many components you can run off a single remote turn on lead? or is there something that must be added when running say three amps, and an active crossover, so 4 total devices that need a remote?
Posted: Wed Sep 06, 2006 1:13 pm
by brent
I am no expert, but I have ran 3 remotes before without any issues. Electronically, I see no issue with running 1 remote across multiple sources, but then again, I have not gotten into high end audio, competitions, ect, so I am unaware of any possible negative outcome.
Posted: Wed Sep 06, 2006 1:18 pm
by Ryan from Ohio
Problem is most remotes have only about 250 or so miliamp capacity. When you get about 2-3 items you run a risk of overdrawing that circuit. In essence, burn your remote turn on lead out.
Anything above 3 devices should have a relay.
Posted: Wed Sep 06, 2006 1:37 pm
by two4fifteen
Posted: Wed Sep 06, 2006 1:58 pm
by MobileAudio219
Yeah, use a relay.... anymore than 2 items off the remote is a bad idea unless youre using a relay....
Posted: Wed Sep 06, 2006 2:09 pm
by two4fifteen
i am only using two amps right now. but now i am looking to add another kicker zx200.2, ssmb6 for my front doors (i finally got around to taking the doors panels off and checking and they should fit quite nicley), and kx2 crossover in conjunction with the amp's crossover to bandpass them between roughly 60 and 150... depending on what sounds best.
i love my q-logic kick panels for their imaging, but they aren't the best for midbass response. this is why i am going to try relocating my midbass to my doors, where many people get great results. i even think i remember someone on here writing that one of their favorite set-ups was tweeter/midrange in kick, and midbass in the door.
Posted: Wed Sep 06, 2006 2:20 pm
by Ryan from Ohio
Actually no not that relay.
The problem is it pulls to much amperage for some remotes.
http://www.radioshack.com/product/index ... age=family
Thats what I use in my remote saver boxes

Posted: Wed Sep 06, 2006 2:22 pm
by two4fifteen
and just one? or one for each?
Posted: Wed Sep 06, 2006 3:51 pm
by GlassWolf
if you have 3 or more devices being triggered, use a relay.
othrwise you'll end up burning out the trigger/remote circuit in the head unit.
Posted: Wed Sep 06, 2006 4:26 pm
by two4fifteen
i got that part, but no one answered the question of, do i need just one?