Page 1 of 1
Mounting 10" sub to sealed box
Posted: Tue Jul 18, 2006 3:39 pm
by ecxtimmy
just put my RF punch 104 sub in my small truck box. I noticed that it leaked around the edges, and the sound wasn't that great, so I put foam around the edge to seal it. Its alot louder now, but i know your supposed to put silicon around the edge, and the back where the wire terminals are, but where do i get the correct silicon and is it required, or will it make that much of a difference. Also, if I want to remove the sub, or get a new one, how hard is it to take the sub out, and if I take it out, will it damage the box
Posted: Tue Jul 18, 2006 3:48 pm
by Justin from Detroit1
You don't need to silicone it. The foam works just fine. Put it under the sub mounting ring, then screw the subwoofer in.
Posted: Tue Jul 18, 2006 3:50 pm
by ecxtimmy
whats the sub mounting ring
Posted: Tue Jul 18, 2006 3:53 pm
by Justin from Detroit1
Where the screw holes are, that is called the sub mounting ring.
Posted: Tue Jul 18, 2006 3:54 pm
by swimmerdude
he means put the foam between the box and the sub. The mounting ring is the outer metal piece of the frame where you put the screws through.
Posted: Sat Nov 25, 2006 2:02 pm
by PrimeTimeBumpin
Seal it up!