Car Audio Central - Ultimate Car Audio Forum and Community

i got some kodas and the speakers have a very big magnet and there kinda deep, they do not fit in my kick panels, the kick panels are too deep, i need to cut about an inch from the opening pod for the woofer to raise that speaker up, BUT when i do that there is not gona be anywere to screw it on too if you dont know what im talking about look at this > {(o)}that inner area is were the woofer is mounted(about 3/8ths) when i cut an inch off there is not gona be anywere to screw the woofer on {( )} so i need a way to make a new piece that will cover the whole 6.5 pod and ill cut it again to make the part that holds the woofer, SO does anybody know how i can do this , i guess what will stick , harden , and give me a new solid flat surface?

PLEASE HELP!!!!!! ive these kodas for about a month someone help!

just make a baffle using 3/4" MDF or a little smaller if you need too. should work.

and how is this baffle supposed to stay on the kick panel?and there made out of ABS.

you cut the baffle to fit the kick panel, put it in, and put the speaker in the baffle and screw it in.

so you make the baffle and fiberglass over top of it...fill it...sand it...paint it...done

you cut the baffle to fit the kick panel, put it in, and put the speaker in the baffle and screw it in.

OHHHHHHHHHHHHH i get you, damn now i know why you said 3/4 inch, so i can screw it , kodas here i come!