Page 1 of 1
2 ROCKFORD FOSGATE P210S4 and Rockford 500.2
Posted: Sun May 21, 2006 4:01 pm
by rlemieux
Need to know what is the best way to wire 2 4 ohm 10" Stage 2 Rockford Fosgates to a P500.2 amplifier.
Amp is rated for 125 W x 2 @ 4 Ohms RMS
250 W x 2 @ 2 Ohms RMS
500 W x 1 @ 4 Ohms bridged RMS
Posted: Sun May 21, 2006 4:04 pm
by Bwcad1
are they single or dual Voice coil subs?
Posted: Sun May 21, 2006 4:55 pm
by rlemieux
Bwcad1 wrote:are they single or dual Voice coil subs?
Single
Posted: Sun May 21, 2006 4:57 pm
by Bwcad1
wire each sub to a channel on the amp.
Posted: Sun May 21, 2006 5:01 pm
by Chris from Washington
Yep, won't be able to bridge it with those subs.
so you'll have to wire each sub into each channel.
Posted: Sun May 21, 2006 8:45 pm
by Robert Wollenberg
Whether you wire them stereo at 4 ohm per channel or bridge it at 8 ohm, the power output should be about the same. I bridge just for the sake of doing it. Honestly though, I'd probably just use one sub and bridge the amp to the one. Forget the second sub all together.