Page 1 of 1
couple of repair questions......
Posted: Sat May 13, 2006 12:58 am
by Pasyngr
1) what kind of glue should I use to replace a sub dust cap, and is there anything I should be aware of when I do this 2) I have a rockford 800.1 and it wont power up, when I checked it out I found that the rem turnon lead is severed on the circut board. Can I just solder it back together? and as above is therer anthing I need to know about ding this?
Posted: Sat May 13, 2006 5:24 am
by Ryan from Ohio
Glue: Use super glue
Board: Goto Radio Shack. They have a "pen" with conductive ink. Scrape away the coatng over that trace and draw a new one on. Or you can smply put a spot of solder on it.
I have repaired circuits before by using solder or even a jumper wire from the initial connector to the first componet in the circuit.
Posted: Sun May 14, 2006 10:04 pm
by Pasyngr
Thanx Ryan, I thought I was on the right track, just wanted to make sure