Page 1 of 1
Physically Wiring a Passive Crossover
Posted: Thu Apr 20, 2006 6:21 am
by solacedagony
Say this is your diagram. Do those dots mean you just solder another wire onto that point to distribute the same signal across two wires? (Referring to the dots at the SPK+ and SPK-.)
Posted: Thu Apr 20, 2006 6:24 am
by Bwcad1
it doesnt have to be that specific point just some where on that wire.
Posted: Thu Apr 20, 2006 8:32 am
by solacedagony
Yea, sorry, I don't think I'm wording my question correctly.
So 2 wires are coming off the input's positive and 2 wires are coming off the input's negative? Each going to the positive and negative of the mid and tweeter. Then on these wires of each way (1 to tweeter, 1 to mid) you'd wire in your caps and coils?
Posted: Thu Apr 20, 2006 8:38 am
by Robert Wollenberg
yes
Posted: Thu Apr 20, 2006 9:49 am
by solacedagony
Ah ok, thanks guys!