Page 1 of 1
How to access these?
Posted: Sun Apr 09, 2006 2:56 pm
by Vindicate
Ok, I was asking this before but I never had pictures... The question again is, How do I get these speakers out of there? The vehicle is a 2002 Nissan Sentra.
Click the pictures to get a bigger image.
View from inside the trunk to the underneath.
View from outside.

\
I can take more pictures if need be, just ask!
Posted: Sun Apr 09, 2006 3:16 pm
by Justin from Detroit1
Why would you want to? THOSE ARE CLARIONS.
I have no idea...
Posted: Sun Apr 09, 2006 3:21 pm
by Vindicate
Cuz I'm thinken of putten my Alpine Type-R Coaxials in there instead.
Posted: Sun Apr 09, 2006 3:25 pm
by William from NOLA
You will probably have to start with the panels around that back panel. Such as the C pillars or if you fold the seats down, you may have some screws on the panels right behind that.
I'd check with a Nissan forum. They'd usually know or have something right there for you to see.
Posted: Sun Apr 09, 2006 3:47 pm
by Ryan from Ohio
Wlecome to fun. I advise you highly to make your mind up before proceeding and whatever you put in there, thats it. Lot of work!
Remove the back seat. Chances are you will have to remove the bench part first then the back rest. Then remove the plastic panels in the back. When you get that done the deck card will need to be slightly folded in the center while lifting. Be careful not to bend it to much, just enough.
Assembly is just as much a pain. Especially to get it all back in correctly and make it look untouched.
When you do this, I highly advise putting some grille cloth over the speakers. That way the suns UV Rays wont mess with them. Cheap insurance also. Keeps thiefs guessing...
Posted: Sun Apr 09, 2006 4:11 pm
by Vindicate
Hmmm... sounds like a huge pain in the ass lol.. Maybe I'll just craft myself some fiberglass kick panels and deal with the front stage and forget the rear.
Posted: Mon Apr 10, 2006 10:31 am
by ridr4lif
That would probably be the best route. Once you have a sub installed you dont really hear the rear speakers anyway.
A nice front stage will be a much better investment than upgrading rear speakers.
Posted: Mon Apr 10, 2006 11:33 am
by William from NOLA
Vindicate wrote:Hmmm... sounds like a huge pain in the ass lol.. Maybe I'll just craft myself some fiberglass kick panels and deal with the front stage and forget the rear.
I think fiberglassing would be more work. Both are a pain in the ass lol
I would agree on making the front stage better. It helps.
Posted: Mon Apr 24, 2006 8:14 pm
by High Society
Are you sure you just can't un clip that plastic covering the speaker? Or just pop out the metal grill? If could could get that off, then you should be able to unscrew them right out.