Page 1 of 1
8guage
Posted: Wed Jan 25, 2006 5:29 pm
by Darthness
If i were to buy this amp:
http://ikesound.com/product-product_id/2119 for my new Eleveation comp 10's, would i be safe using 8guage wiring with it? i'd be running it at 2 ohms, 400w.
Posted: Wed Jan 25, 2006 6:07 pm
by smoker
i reckon............althought the subs will easily handle more than that.......i have yet to put less than 500 per sub to any comp 10 or 12..........
Posted: Wed Jan 25, 2006 6:25 pm
by Darthness
they're rated for 220w RMS, im not really trying to risk blowing them, i'm ona tight budget ya know.
Posted: Wed Jan 25, 2006 6:28 pm
by Darthness
btw so are we saying that 8guage will be fine for that amp? otherwise i have to run another powerwire... or upgrade to 1/0 gauge, which im not really wanting to do atm.
Posted: Wed Jan 25, 2006 8:12 pm
by Justin from Detroit1
I would not put 500w RMs to a Comp, that is crazy. They are 250w RMS, 500 max. 8 gauge should be ok, just monitor it. If the wire feels warm at all, then time to upgrade to 4 gauge.
Posted: Wed Jan 25, 2006 8:15 pm
by veggie-man
http://www.streetwires.com/products/wireGauge.cfm
someone sent me that link... its a nice little site... if your only running 250 RMS i think you would be fine
Posted: Thu Jan 26, 2006 10:18 am
by Darthness
the amp will be putting out 400w, the subs handle 250.
im actually trying to find an amp that'll do 500w @ 2 ohms, any ideas?
Posted: Thu Jan 26, 2006 10:48 am
by High Society
So your going with two comp 10's then right? Why not two 12's? For my 600rms I went with 4g, I'd do the same for 500rms. knuknoceptz have 4g kits for like 20-25. 200 watts each should have them wangin just fine.