Page 1 of 1
wiring problem for sub
Posted: Sat Jan 07, 2006 9:08 pm
by okayyyy
i have a hifonics atlas 12sq.. a 13 inch square sub, and the wiring diagram that came with it, doesnt make sense.. i need to know where to route the speaker wire for 4ohm. can anyone help me??
Posted: Sat Jan 07, 2006 9:15 pm
by Bwcad1
what is the voice coil ohm rating on the sub? what kind of amp are you running it on? what is the minimum inpedence of the amp?
Posted: Sat Jan 07, 2006 9:42 pm
by okayyyy
Bwcad1 wrote:what is the voice coil ohm rating on the sub? what kind of amp are you running it on? what is the minimum inpedence of the amp?
dual 2ohm voice coil, min inpedence is 4 ohms, and im running it on planet audio dx400 amp
Posted: Sun Jan 08, 2006 5:46 am
by Ryan from Ohio
You want to series the dual 2 Ohms to get a 4 Ohm nominal.
Put the sub so one coil is on the left, the other on the right.
Now pull some speaker wire so its just one wire on each side, enough to reach each side.
Put one lead on one sides +, the other on the opposites -
Then run just a single piece runner between the leftover + and -
done
Posted: Sun Jan 08, 2006 7:44 am
by Bwcad1
thanks ryan! i think i fell asleep lol
Posted: Sun Jan 08, 2006 11:31 am
by okayyyy
Ryan from Ohio wrote:You want to series the dual 2 Ohms to get a 4 Ohm nominal.
Put the sub so one coil is on the left, the other on the right.
Now pull some speaker wire so its just one wire on each side, enough to reach each side.
Put one lead on one sides +, the other on the opposites -
Then run just a single piece runner between the leftover + and -
done
does it matter which lead goes back to the amp?
Posted: Sun Jan 08, 2006 11:44 am
by Bwcad1
check out bcae1.com that has a lot of information about series parallel wiring and plenty of other info!
Posted: Sun Jan 08, 2006 12:01 pm
by smoker
okayyyy wrote:does it matter which lead goes back to the amp?
you are basically making the amp see 1 4 ohm load....take the negative of one coil to the amps negative......take the positive of the other coil to the amps positive then run a jumper between the to leads that are left on the speaker..........
Posted: Sun Jan 08, 2006 3:52 pm
by okayyyy
smoker wrote:you are basically making the amp see 1 4 ohm load....take the negative of one coil to the amps negative......take the positive of the other coil to the amps positive then run a jumper between the to leads that are left on the speaker..........
thank you so much! that did 'er!