Car Audio Central - Ultimate Car Audio Forum and Community

Ok my rear speakers arent hooked up, why I dont know. They are 6x9s. The wires wont reach the speakers. The speakers are up inside the rear deck. Not hanging by brackets like in the cutlass i drove. How do I take em out? Does the top of the deck come off? I plan on buying 2 kicker 6 1/2 midbass speakers (125 rms) to put in there so I wanna make sure they will fit and such. Plus i want my damn rear speakers working for now.

what kind of car is it?

Dude...look at the title of the thread.

Its a 95 Sunfire.

smoker wrote:what kind of car is it?

lol

i havnet taken them out in that specific car but i had to do an install on a galant with the same thing i belive... i had to remove the covered part of the deck to do that we had to remove the back seat... pop up the deck cover (removed the high brake light) and remove the speakers.

my seat folds down hehehe

ridr4lif wrote:Dude...look at the title of the thread.

Its a 95 Sunfire.

hee im real bad about reading the whole title

You will want to take out the rear seat.

GM Cars... Usually two Torx type screws or two pull tabs on the bench seat part. Like where it meats the floor carpet. Take them two off pull the bench seat out. Then there are like 203 nuts holding the backrest on. Take off and lift UP!.

Next is the plastic that touches the rear deck. Remove ONE side.

THe deck should come off with a bit of fight, fold GENTLY. Bend it in a few spots but no TIGHT bends...

Make sure you have everything you need and only do this once as its a pain in the arse!

ahhhhh SON OF BITCH!!! what all do i need to do this?

It sounds easier to make new holes in the side panels in the rear for 6 1/2s