Page 1 of 1
Wire Question
Posted: Sat Oct 30, 2004 12:10 pm
by daykareboards
K I have 2 12 RF subs rated @ 200w rms 4ohm. My amp is rated 560w rms bridged 220w rms x2 4 ohm. should i run each sub off its own channel or bridge the amp?
Posted: Sat Oct 30, 2004 4:14 pm
by Justin from Detroit1
Just wire each sub to one channel.
Posted: Tue Nov 23, 2004 8:12 pm
by GlassWolf
this is a 4 channel amp?
bridge it and stick one 4 ohm sub on each of the two bridged channels
Posted: Thu Nov 25, 2004 4:11 pm
by 6three6mafia6
it depends are the subs dvc?is it a 4 channel or 2 channel amp?
Posted: Thu Nov 25, 2004 4:19 pm
by daykareboards
hey, thanks for responding but i havent been on in awhile and everything is squared away now... i dumped the PA amp and got a MTX 2300X