Page 1 of 2
-Another Wiring Question-
Posted: Thu Sep 29, 2005 5:01 pm
by audiocr381ve
What ohm sub would I need to buy, if I wanted 3 subs, running off a JBL bp600.1? What would work?
Posted: Thu Sep 29, 2005 7:01 pm
by GlassWolf
three 6 ohm subs, or three dual 3 ohm coil subs.
either way you'll get a 2 ohm load with three subs on a mono amp.
...
Posted: Fri Sep 30, 2005 3:10 pm
by audiocr381ve
I haven't seen much 6 ohm or DVC 3 ohm subs LOL.
Would it be easier to run 4 subs, as far as FINDING subs?
Posted: Fri Sep 30, 2005 3:45 pm
by Bwcad1
yup
...
Posted: Fri Sep 30, 2005 4:51 pm
by audiocr381ve
What OHM sub if I wanted 4 of them on the bp600.1?
Posted: Sat Oct 01, 2005 7:34 am
by audiocr381ve
What ohm subs If I needed 4 of them !!
Posted: Sat Oct 01, 2005 8:39 am
by GlassWolf
to get a 2 ohm load on a mono amp?
four 2 ohm SVC subs, or four 4 ohm DVC subs.
...depending on what's offered by that make and model of sub you choose.
you could also use four 8 ohm SVC subs in parallel.
Posted: Sat Oct 01, 2005 8:39 am
by GlassWolf
note four subs on a 600.1 amp equals 150wRMS each.. not a lot of juice
...
Posted: Sun Oct 02, 2005 5:55 am
by audiocr381ve
Tell me this kiki, would it be better to buy two 300 watt 8's, or four 150 watt 8's. Wouldn't it be the same?
I'm going with 8's due to limited room in the new truck. I haven't seen anyone throw some 10's in, I don't know how it would work.
Posted: Sun Oct 02, 2005 8:40 am
by GlassWolf
yeah, if the subs aren't reaching peak output then yes two of the same subs with twice the power will have the same output.