Car Audio Central - Ultimate Car Audio Forum and Community

I have 2 audiobahn 15 in Alumq subs which are both six ohms. I have a Audiobahn A1504DP - Audiobahn 4 Ch. 1800 Watt Amplifier
4 Ohm Stereo: 150x4

2 Ohm StereoL: 300x4

1 Ohm Stereo: 450x4

4 Ohm Mono: 300x2

2 Ohm Mono: 600x2
if i set these to subs up in Parallel / Parallel than that should work for this amp correct?? please give ne help all suggestions needed

Parallel/Parallel will give you a final impedance of 1.5 ohms, lower than your amp can handle. If you wired them parallel/series, you would get 6 ohms, so you would be losing power.

Thats a very strange v.c. combo, and i dont know why they would do that.

tedd

6 ohm subs are used for three-subwoofer setups on a mono amp.
6/3=2 ohm load