Page 1 of 1
how to setup amp
Posted: Mon Sep 19, 2005 8:46 pm
by baldguy7171
I am new to all conerning car audio. I recently purchsed two ten inch kickers in a glass case and a legacy amp red series 2. The amp is 400w by 4 channels. I was told i was gonna need a 4 gauge wire. I would like to know what kits are the best and most inexpensive that i would need to hook up my amp and subs. Im putting them in a honda accord 92. I would like any tips or comments as to what i should do or buy. Is a legacy amp really that bad, im just asking i only got it for $50 was it worth it?
Posted: Mon Sep 19, 2005 8:49 pm
by ridr4lif
Running only 400 watts, you probably could get away with only 8 guage, but if you ever feel like upgrading (which you most likely will do), then go with 4 guage. Check out
http://www.knukonceptz.com and look for a 4 guage kit that includes:
-Power cable
-Ground cable
-RCA's
-Remote turn on lead
-It will probably also include small connectors and whatnot.
edit: also, why are you using a 4 channel amp for 2 subs? what kicker subs do you have?
tedd
Posted: Mon Sep 19, 2005 8:51 pm
by baldguy7171
thanks for the help ridr4lif.
Posted: Tue Sep 20, 2005 3:14 am
by Ryan from Ohio
I would get 4 Ga because I have this itching feeling that in a month or less you will be asking about more powerfull amps.
Posted: Tue Sep 20, 2005 4:41 am
by smoker
more powerful than the almighty legacy? 400 x4 is probably actually 50 x4 but the increased spl through engine noise should make it sound louder......
Posted: Tue Sep 20, 2005 4:56 am
by GlassWolf
what is the model of the exact amp you have?
how many ohms is the box you have? is it one pair of terminals or only one terminal set for both subs on the box?
I'm trying to figure out how you'll wire this and how much actual power it'll be.
that legacy amp is terrible.. can it be returned?