Page 1 of 1
is this a good idea
Posted: Sat Aug 13, 2005 9:42 pm
by syang
like i said before i have got my lanzar amp it's working pretty well i like it...right now i have my infinity refences 10" sub 1000w peak and 250 rms being bridge on the lanzar 421 amp... i was wondering if i could hook up 2 of the RE subs in the same channel... so in all there is three subs being powered by half of the amp. cause the amp is a four channel amp... sorry if i'm confusing you
Posted: Sat Aug 13, 2005 10:31 pm
by William from NOLA
What are the voice coil configurations to each of the subs and what ohms are each? What is the amp's rated power?
Posted: Sun Aug 14, 2005 7:53 am
by syang
all the subs are 4 ohms and the amp is 1000 max, 250 max per channel and 125 rms..
Posted: Sun Aug 14, 2005 9:31 am
by William from NOLA
Are any of the subs dual voice coil? and Is that 125 rms at 4 or 2 ohms?
Posted: Sun Aug 14, 2005 9:36 pm
by syang
the 125 rms is at 4 ohms
Posted: Sun Aug 14, 2005 10:00 pm
by William from NOLA
Well, you could (assuming each sub is a single voice coil), put the two RE's on either the left or right channel and use the Infinity on the opposite. Or if you wanted to use all 4 channels, bridge the front set of outputs and put the Infinity on those, then put each RE on an individual channel on the rears.
Posted: Mon Aug 15, 2005 5:00 am
by smoker
im that amp is stable under 4 ohms on the bridged output you could series wire the two re subs together for 8 ohms, then parallel wire the infinity and the re setup and this would give you 2.66 ohms....