Car Audio Central - Ultimate Car Audio Forum and Community

Okay so today i got my amp installed. A few minutes after i got back from that i decided i'd put my memphis speakers up front because They sound sooo much better then my blaupuntks.

Anyway, a little later i find out that i can't get the adapters we made out and decide to put the blaupunkts back in. As i was screwing the speaker back in, my screwdriver slipped and poked a hole through the surround.. When i hooked it back up, the shit wouldn't even play, woudl the hole cause this or what?

Im going to try plugging another speaker up before i have to replace the feckin wires, that'll be a bitch

a hole in the surround shouldnt keep it from playing, is it possible that a wire came off? ive seen that a lot on door speakers, sometimes they dont lock and all the wiggling gets em loose

yea , ifeel ya darthness.. i did that to one of my speakers from my diamond audio component set. my heart broke when that screwdriver slipped.. but back to you topic, i had no problem with them playing. i cant tell the difference, i just covered it with some electrical tape, cant tell the diff.. how far did the screwdriver go in? you might have broke the VC inside?

nah, it was a tiny slip thats all. I'll get out there in a few minues andcheck it out.. i hope i can find my dad's old sony speakers and see if they'll work.

wonder if they'll handle 200w

lol they are gonna blow up!!! video tape it and put it on realm of excursion! :excited:

I think these are pre-xplode shit,so i might run them :P

ahhh ook lol