Page 1 of 2
Trunk rust, 1/4 in angle die grinder
Posted: Mon May 16, 2005 3:56 pm
by Mithrandir
is 50 bucks a lot for a angle die grinder, also Where can I buy the rubber pieces for use with the surface prep pads and will I need a high speed sander as well to get the rust off or can I just use the sanding pads for the die grinder? Its not like all over the top of the trunk just along the edge where it closes.
Posted: Mon May 16, 2005 3:58 pm
by dmeyer07
no 50 bux isn't bad... i bought mine for about 60
Posted: Mon May 16, 2005 4:30 pm
by Mithrandir
I might just order this
http://www.tooltopia.com/index.asp?Page ... rodID=7702
it has everything i need and will fit the pads i all ready bought
Posted: Mon May 16, 2005 4:31 pm
by dmeyer07
N2b
Posted: Mon May 16, 2005 4:34 pm
by Mithrandir
n2b? not too bad?
Posted: Mon May 16, 2005 4:35 pm
by dmeyer07
Well what do you think it means?
Posted: Mon May 16, 2005 4:35 pm
by dmeyer07
Yes it means not too bad. I like it, seems nice for the price!
Posted: Mon May 16, 2005 4:39 pm
by Mithrandir
u could have included that all in one post hehehehe
Posted: Mon May 16, 2005 4:40 pm
by dmeyer07
lol i know but i pushed enter and the damn page reloaded and it posted, so i figure i'll just repost. I guess i forgot the damn edit button!
Posted: Mon May 16, 2005 6:25 pm
by GlassWolf
Lowes has a B&D Firestorm 4.5" angle grinder for $39
Home Depot has a Ryobi for the same price
both as I recall are 10KRPM, 6.5A
that and some #80 grit discs will grind off rust pretty fast.