Page 1 of 4
Brax setup
Posted: Mon Oct 10, 2016 12:16 pm
by johnsahl
Hi all,
I am about to start putting in a Brax X2400 to run my four doors and a Brax X1000 for my subwoofer, but I am a little unsure if I should opt for a new AGM battery, or just keep the standard 100Ah battery already there?
Re: Brax setup
Posted: Mon Oct 10, 2016 6:13 pm
by Chris from Washington
johnsahl wrote:Hi all,
I am about to start putting in a Brax X2400 to run my four doors and a Brax X1000 for my subwoofer, but I am a little unsure if I should opt for a new AGM battery, or just keep the standard 100Ah battery already there?
Hi, Welcome to the forum.
Do you plan on doing more engine off listening to the stereo?
A bigger battery is just going to give you more engine off time.
I would just get a good reliable battery, that meets or slightly exceeds what the car requires.
How is your charging system?
Re: Brax setup
Posted: Mon Oct 10, 2016 9:28 pm
by johnsahl
Thank you. Charging system is almost new, battery as well.
Not planning alot of off engine time.
My system is: iPad, HRT iStreamer, Audison Bit Ten D, Brax amplifiers, Mundorf caps, Alpine SPR-60C speakers and a Hertz Mille ML2500 sub
Re: Brax setup
Posted: Tue Oct 11, 2016 2:12 pm
by Chris from Washington
I honestly wouldn't bother with replacing the battery.
The only thing I would do, is do the
Big 3 for your wiring and you should be OK.
Re: Brax setup
Posted: Wed Oct 12, 2016 12:15 am
by johnsahl
Thanks.. I already did Big 3 as well, and will hopefully have time to install this weekend!
Re: Brax setup
Posted: Sun Oct 16, 2016 1:09 pm
by johnsahl
Re: Brax setup
Posted: Mon Oct 17, 2016 3:48 am
by Chris from Washington
wow this is going to look nice.
be sure to add the pics of your build to your
garage, that way they don't get lost in the forum.
Re: Brax setup
Posted: Mon Oct 17, 2016 10:28 am
by johnsahl
I will look at uploading them there when I am done.
Placement of caps, any reasons not to put them here?

Re: Brax setup
Posted: Tue Oct 18, 2016 10:44 am
by Chris from Washington
I think that would be OK.
Car Audio Power Capacitors
Re: Brax setup
Posted: Tue Oct 18, 2016 2:27 pm
by johnsahl
Got a little more done tonight, and tomorrow the caps are going in as well. Have been fiddling with the mount in order to have them sitting firmly in that position..
